Highly concentrated, unstabilised chlorine granules.

Rapid dissolution and immediate effectiveness.
Unstabilised product with 72% active chlorine.

Advantages:
Chloryte® is composed of calcium hypochlorite granules, an unstabilised chlorine that dissolves very quickly and acts as a shock treatment to remove impurities from the water quickly.

• As it is a product without chlorine stabiliser, it allows the pool to be treated without the risk of over-stabilisation.

Recommendations for use:
Carry out the treatment with the filtration system running and with the pH between 7.0 and 7.4.

• Spread Chloryte® evenly over the entire surface of the water when no one is in the pool.

• If the water temperature is below 20°C or if the pool is less than 1 m deep, dissolve Chloryte® in a clean bucket of warm water (max. 400 g / 10 L of water) and pour it directly into the pool in front of the injection nozzles.

• If the water becomes cloudy: check the pH (it may need to be corrected with acid) and leave the filter pump running for a few hours until the cloudiness disappears.

• Before using this product in hard water, carry out a pre-treatment with Calcinex® to remove limescale.

Recommendations:

Leave the filtration pump running for at least 12 hours. Perform this treatment at night, after the last swim of the day.

• Do not dose this product in the skimmer or any other dosing system (floating doser, chlorine doser, etc.).

• The pool can only be used again when the chlorine level is below 3 mg/L.

For pools with all types of filtration (physical treatment).
For all pool sizes.
Where: directly in the water.
When to dose: whenever necessary.
Dosage: apply 150 g per 10 m3.